RF Control Status

For Sennheiser 2000 series and evolution wireless G3 devices Firmware 1. 7. 0 or higher needs to be present on the receivers to support the remote control protocol.  With the additional ScanPacks the scan data can be stored as *. csv file and uploaded to your personal Dropbox or sent as attachment via email. The *. csv file I can be loaded from third party software for frequency coordination and planning.  The scan window allows you to use one of the recognized Sennheiser devices to scan the RF environment.  During start up RF Control will scan your network for connected devices.  RF Control remotely controls up to 24 channels of Sennheiser* and Shure* wireless receivers in one application, side-by-side.  Dedicated screens have been carefully developed to give you control to parameters that are relevant in a live situation while securing access to the ones that might be harmful to the safety of the system.  The full screen plot window of the iPad version allows to scroll through the recorded RF and audio levels to look up for problems and drop-outs even after hours of recording.  Sennheiser, EM 6000, EM 3732, 2000 series, evolution G3 / G4 are brands, products or trademarks of Sennheiser electronic GmbH & Co.  The intuitive user interface provides a quick overview of the most vital parameters of your wireless receivers.  Sennheiser: EM 3732*, 2000* series and evolution G3 and G4* wireless receivers.  The device list allows access to all devices in the network and selection of 24 devices for monitoring.  A plot of the RF and AF levels is displayed over time, making it the perfect companion for walk tests and spotting dropouts in your audio.  Scan is not supported by Shure devices.  Either ScanPack will unlock the RF Inspector for sample accurate readout of the scan data at your fingertips.  The order of channels can be freely arranged and will be restored at the next start of RFControl .  The frequency plot can be used to drill down the spectrum and look for free frequencies.